Serial Sensor Signal Conditioning

USB and Modbus RS-485

Serial Sensor Signal Conditioning

Serial signal conditioners read sensors and send the readings to a computer as digital data. Two ways: USB, when the sensors are near a PC – four channels on one cable, software included – and Modbus RS-485, when there are many points or long distances to cover on one cable to a PC or PLC.

ROI-USB serial sensor signal conditioner: four sensor channels to a PC over USB
USB · ROI-USB

Sensors straight to a PC

Plug the ROI-USB into a spare USB port, wire up to four sensors and start reading. The module is powered by the PC, scales each reading to engineering units, and comes with ROI viewing and recording software (Lite edition) for charts, data files and live readings in Excel.

VersionConnectsDetails
10K thermistor4 × 10K NTC thermistorsUSB thermistor recording
4-20 mA4 × 4-20 mA transmitters (transmitter power not included)USB 4-20 mA recording
0-5 V4 × 0-5 V signal conditioners (conditioner power not included)0-5 V signal monitoring
Wiring diagram: 4-20mA transmitters wired to an ROI-USB serial sensor signal conditioner

Example: 4-20 mA transmitters wired to a USB converter – two wires in, two wires out.

Modbus RS-485 · ROI-IOM

Many points on one cable

When sensors are spread out or there are more than a few, Modbus RS-485 carries them all on one cable to a PC, PLC or SCADA system. Transmitters feed ROI-IOM I/O modules, configured and tested as part of a Robert Owen system – from a few points to hundreds.

  • 4-20 mA, 0-30 V and switch-contact inputs per module
  • Thermistors, RTDs and potentiometers through our transmitters
  • Relay outputs for alarms and control
  • Modbus RTU or ASCII, our own firmware
ROI-IOM Modbus RS-485 I/O module

USB or RS-485?

USB (ROI-USB)Modbus RS-485 (ROI-IOM)
Best forA few sensors near a PCMany points, long distances, PLC or SCADA
Channels4 per module4 inputs per module, many modules per cable
Reads intoA Windows PCA PC, PLC or SCADA system
SoftwareROI viewing and recording software includedSoftware or PLC/SCADA setup as part of the system
How it’s soldModuleComplete system

No cable possible at all? See wireless signal conditioning.

Serial sensor signal conditioning – common questions

What is a serial sensor signal conditioner?

A device that reads sensors, converts them to scaled digital readings and sends them to a computer over a serial connection such as USB or RS-485.

Do I need software?

The ROI-USB includes ROI viewing and recording software. Modbus RS-485 systems come with software or PLC/SCADA setup as part of the system.

Does the ROI-USB need a power supply?

No – it is powered by the PC. 4-20 mA transmitters and 0-5 V signal conditioners need their own supply.

How many sensors can I read?

Four per ROI-USB. With Modbus RS-485, many ROI-IOM modules share one cable – from a few points to hundreds.

Sensors to connect to a PC or PLC?

Tell us the sensors, how many and where the readings need to go.

Questions? Contact us – we look forward to answering them.

Like us on Facebook  |  Follow us on X

Scroll to Top